What to do if my Verderflex Water Pump has low flow/pressure?
If your Verderflex Water Pump is experiencing low flow or pressure, start by checking the pipe-work and valves for any blockages. Ensure the suction pipe-work is as short and large in diameter as possible and correct the piping layout. Also, make sure that the suction or discharge valve is open and that suction/discharge lines are properly secured.
How to reduce abnormally high temperature in Verderflex Dura MK IV 05 Water Pump?
If your Verderflex Water Pump has an abnormally high temperature, it could be due to several reasons. First, ensure you are using the correct lubricant by consulting the manufacturer. Next, check the lubricant level and add more if it's low. Also, the product ambient temperature might be too high, so consult the manufacturer regarding the maximum temperature. Finally, check for and remove any excess shims if the pump is over shimmed.
What to do if hose is pulled in to pump housing of Verderflex Dura MK IV 05?
If the hose of your Verderflex Water Pump is being pulled into the pump housing, the inlet pressure might be too high, so reduce it. Also, check the hose for blockages or incorrect fitting and remove any obstructions. If there are large particles in the product, mount a sieve or filter in the suction line, ensuring it doesn't limit suction below accepted levels.
General| Model | Dura MK IV 05 |
|---|---|
| Self-priming | Yes |
| IP Rating | IP55 |
| Pump Type | Peristaltic Pump |
| Hose Material Options | EPDM |
| Hose Size | 5 mm |
To Next Page
