To Next Page

To Previous Page

Initial Set-up

Vacuuming with UV-C

1. Attach the vacuum cleaner to

the base unit. Insert it into the

base unit and then press the

rear down ﬁ rmly. Press lever

down when docking vacuum.

Then pull up until lever clicks

to lock. (See Figure 1)

2. Turn on the cleaner using the

on/off switch.

The UV-C bulb will turn on when

the UV-C safety switch is in

contact with the surface to be

cleaned. You can conﬁ rm that the

UV-C light is on by checking the

conﬁ rmation windows on the top of the unit.

Avoid vacuuming ﬁ ne dust, such as cement and plaster, as this will block the

ﬁ lters. If ﬁ ne dust is picked up, the ﬁ lters, dust container and tools must be

thoroughly cleaned immediately after use.

CAUTION: Direct exposure to UV-C light can cause serious skin burn and eye

inﬂ ammation from short wave ultraviolet radiation. Radiation from this bulb is

harmful to the eyes and skin.

CAUTION: Do not override the safety switches manually.

CAUTION: Do not attempt to pick up large or sharp objects as these may cause

damage to the vacuum cleaner.

Using the Hand Vacuum Only

1. Turn the cleaner off using the on/

off switch.

2. To remove the cleaner from the

base, press the lever at the rear of

the vacuum base. (See Figure 1)

3. Lift the hand vacuum from the

base.

Certain tasks may require the use

of the nozzle or brush attachments.

These tools are stored in the base

unit. (See Figure 2)

Figure 1

Figure 2

Verilux CleanWave User Manual

Other manuals for Verilux CleanWave