8
To Replace the Bulb:
1. Unplug lamp from power source and, if
necessary, allow time for the bulb to cool.
2. Remove the top of the lamp as described in
Step Two above.
3. Remove the old bulb by twisting it
counterclockwise until the bulb pins align
with the openings on the bulb mount. (See
Illustration 2.) Pull the bulb from the mount and
discard according to local regulations.
4. Insert the new bulb into the bulb mount and
rotate it clockwise until it clicks in place.
(Either pin in either opening is fine. See
Illustration 3.)
5. Re-install the top cover, reversing the
procedure you completed in Step Two of the
Lens Replacement section above.
Your lamp is made from high-quality materials that will last for many years with
minimum care. You may want to periodically clean the lamp using a mild non-
abrasive cleaner and soft cloth. When cleaning, make sure you have turned off
and unplugged the unit and allowed sufficient time for it to cool.
WARNING:
To prevent risk of shock or personal injury when cleaning
lamp, make sure you have turned off and unplugged the lamp and allowed
sufficient time for the bulb to cool.
After cleaning the lamp, wipe away all moisture and let the
lamp dry completely before restoring power.
WARNING:
Always unplug lamp before performing bulb replacement or
installation and allow sufficient time for the bulb to cool.
WARNING:
This bulb contains a trace amount of mercury. For more
information on clean-up and disposal, see www.epa.gov/cfl.
Care and Cleaning
Lens/Bulb Removal and Replacement — continued
Illus. 2
Illus. 3
Bulb
removal
closeup
Bulb
insert
closeup
For clarity, lamp shown
with lens removed.
To Next Page
Loading...