89
RF Exposure Information (SAR)
This device meets the government’s requirements for
exposure to radio waves.
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless device employs a unit
of measurement known as the Specific Absorption Rate, or
SAR. The SAR limit set by the FCC is 1.6 W/kg. *Tests for SAR
are conducted using standard operating positions accepted
by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level,
the actual SAR level of the device while operating can be
well below the maximum value. This is because the device
is designed to operate at multiple power levels so as to use
only the poser required to reach the network. In general, the
closer you are to a wireless base station antenna, the lower
the power output.
The highest SAR value for the model device as reported to
the FCC when tested is 0.83 W/kg as described in this user
guide.
While there may be differences between the SAR levels of
various devices and at various positions, they all meet the
government requirement.
The FCC has granted an Equipment Authorization for this
model device with all reported SAR levels evaluated as
in compliance with the FCC RF exposure guidelines. SAR
information on this model device is on file with the FCC and
can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid
For body worn operation, this device has been tested
and meets the FCC RF exposure guidelines for use with
an accessory that contains no metal and be positioned a
minimum of 0 cm from the body. Use of other accessories
may not ensure compliance with FCC RF exposure guidelines.
To Next Page
Loading...
Need help?
General
