1. Place the cutting blade near the top front edge of the tree stump.
2. Set the brake to lock position
3. Set the throttle to SLOW (START) DISENGAGE.
4. Set engine switch on handlebar to ON.
5. Tilt the machine on its wheels, lifting the cutting wheel off the
ground.
6. Hold in the dead man’s grip bar and start the engine.
7. Allow the engine to warm up for two minutes at idle before grinding.
8. Set the throttle to FAST to ENGAGE clutch.
IMPORTANT INFORMATION:If the cutting wheel is too low, the
machine may start to climb over the stump and become unstable
9. Place the middle of the cutting wheel approximately one inch (2.5
cm) above and
3/4 to 1 1/2 inches (2-4 cm) into the stump.
10. Place the cutting wheel in the upper front edge of the stump. Swing
the cutting wheel from side to side while lowering it about one inch
(2.5 cm) after each pass until the front edge of the stump is gone.
11. Before moving the machine forwards, you should ensure that the
cutting wheel is above the ground and located on either side of the
stump. Move the machine forward by releasing the brake, pushing it
forward, activating the brake again and repeating steps 9 and 10.
12. Repeat steps 9 through 11 until the upper portion of the stump has been removed. DO NOT cut deeper than
ground level at this stage.
13. Set the throttle to SLOW/(START) DISENGAGE and wait until the cutting wheel
stops rotating.
14. Release the brake and pull the machine away from the stump.
15. It may be necessary to clear wood chips from the area around the stump.
16. If you want to grind below the ground level, it may become necessary to adjust the handle position to achieve a
better hand and arm work position. Pull the handle control lever and adjust the handle to the desired position.
17. Repeat steps 6 through 10 until you reach the desired depth.
18. Shut off the machine when you are done.
Operating on hills
Be very careful when operating the stump grinder on hills because the machine can slip or move unexpectedly. NEVER use
the machine on grades of 10 degrees or steeper.
Transport
Most stump grinders can be transported in a truck, trailer, van or a large SUV (Sport Utility Vehicle). Most stump grinders
are equipped with two lifting handles on each side so that two people can lift the machine if necessary. DO NOT attempt
to lift the machine alone. Use safe lifting techniques and DO NOT exceed your physical limitations. Secure the machine
with tensioning belts, chains or other approved materials. Consult your rental dealer about specific moving and lifting
To Next Page
Loading...
Need help?
General
