Vermeer SC292 User Manual

©2015 Green Manufacturing, Inc. 1
Vermeer SC252 & SC292
Upgrade Wheel Assembly
If you have any questions or concerns, please call 1-800-473-3683
BEFORE YOU BEGIN
Read these instructions completely and
carefully
 Note to installer – Be sure to leave
these instructions for the consumer’s use
 Note to consumer – Keep these
instructions with your Owner’s Manual for
future reference
 Skill level – Installation of the wheel
requires intermediate mechanical skills.
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under any
warranty
IMPORTANT - Before you continue,
please check the packing list to make sure it
matches the contents of the boxes.
Disconnect Power
to machine to prevent any machine
components from moving before proceeding.
Failure to do so could result in death or
serious injury.
FOR YOUR SAFETY read and
observe all CAUTIONS and
WARNINGS shown throughout
these instructions. While
performing the installations that
are described in this booklet, gloves
& safety glasses or goggles should
be worn at all times.

Vermeer SC292 Specifications

General

Cutting Depth Below Ground	12 in (30.5 cm)
Engine Power	26.5 hp
Fuel Tank Capacity	5 gal (18.9 L)
Cutting System	Yellow Jacket Cutter System
Transport Width	35 in (88.9 cm)
Rotor Diameter	17 in (43.2 cm)

Summary

Before You Begin

Disconnect Power

Ensure machine power is disconnected before proceeding to prevent serious injury.

For Your Safety

Read and observe all safety cautions and warnings; wear gloves and safety glasses.

Installation Preparation

Assembly Instructions

Upgrade Assembly Diagram

Greenteeth™ Guarantee

Material Safety Data Sheet

Product Identification

Details trade name, chemical family, formula, and CAS number for the product.

Hazardous Ingredients

Lists hazardous components, their ratings, and required protective equipment.

Physical Data

Provides boiling point, melting point, solubility, vapor pressure, and specific gravity.

Fire and Explosion Hazards Data

Details flash point, flammability, explosive limits, and fire-fighting procedures.

Health Hazard Information

Explains routes of entry, effects of overexposure, acute and chronic health effects.

Reactivity Data

Covers stability, conditions to avoid, incompatible materials, and decomposition products.

Spill or Leak Procedures

Outlines steps for handling material spills, including isolation, cleanup, and disposal.

Special Protection Information

Specifies respiratory protection, ventilation requirements, and necessary personal protective equipment.

Special Precautions

Provides guidelines for safe handling, storage, and work practices to minimize exposure.