-4-
REV. 10/2018
ATTENTION:
IT IS IMPORTANT THAT YOU READ THE FOLLOWING NOTE
NOTE: If during the installation process you
have difficulty fitting frame components
together, use an adjustable wrench to open
the end of the receiving tube as shown
below. Close wrench down around bent
portion of tube and bend wall outward. It
may also be helpful to hit the center of the
swage at the end of the tube to create more
of a lead.
What you’ll need
Strike with
Hammer
Work Gloves 2 Step Ladders
Safety Goggles
Chalk Line & Mason Line
or Nylon String
Pencil/Marker & Felt Marker
Tape Measure
Hammer
Shovel or Post Hole Digger
Items you may need
Cordless (14 or 18 volt) or Elec-
tric Screw Gun with 5/16"
Socket Drive
Hammer Drill, Masonry Drill Bit 1/2” x 8”, vise grip or other quick clamp (to
assist to plumb frame or clamp sheet metal), adjustable wrench and open
ended wrench, 3/4” & 1/2”
To Next Page
Loading...