EDGE 500
- User Manual
EN - 1
CONTENTS
Important notes ........................................................................................................... 1
Overview ..................................................................................................................... 2
Controls and connections ............................................................................................ 3
Connection examples .................................................................................................. 5
Components, configuration and performances............................................................ 8
Placement ................................................................................................................... 9
Usage suggestions .................................................................................................... 12
Technical specifications ............................................................................................. 13
Block diagram............................................................................................................ 14
IMPORTANT NOTES
LOOKING AFTER THE PRODUCT
• Never apply excessive force to the structures or controls (knobs, switches).
• Do not stress the speaker in transit or during use.
• Do not place the device close to heat sources, in damp or dusty places or close to
strong magnetic fields.
• When possible, do not place the speaker close to units which generate strong
interference, such as radio and TV sets, monitors, etc.
• Never insert objects or liquids of any kind inside the device, for any reason.
• Clean using a soft brush or an air jet only; never use detergents, solvents or alcohol.
• When disconnecting cables from sockets, always take hold of them by the connector
and not by the cable itself, and when winding take care to avoid knots or twisting.
• Do not expose the speaker to direct sunlight.
CONNECTING TO THE MAINS
• To avoid the risk of electric shock, do not make connections with wet hands.
• Make sure that the mains voltage is the same as that indicated on the control panel.
• Connect the speaker to a mains socket with earth contact.
CONNECTING TO A MIXER
• Always use good quality screened cables.
• Before making the connections, check that all the speakers you are about to connect
are switched off. You will avoid noisy, if not hazardous, signal peaks.
IN CASE OF MALFUNCTION
• In case of malfunction, contact only an authorised service centre.
To Next Page
Loading...
