Verseo e-smooth - Important Pre-Treatment Notes

General Guide to using interchangeable Roller Tips
For successful treatment, please follow this guide: -
t Install batteries: Turn battery compartment cap at end of wand anti-clockwise to remove. Insert
batteries and replace cap by pressing and turning clockwise.
t Interchangeable Roli er Tips: e -SMOOTH comes with larg e Roller Tip already inserted in wand. To
change to smaller tip unscrew silver locating ring. Pull out clear plastic surrounding Roller Tip. Plug in
small Roller tip and replace silver locating ring.
The small Roller Tip is most suitable for removing facial hair or eyebrows. The larger Roller Tip is suitable
for larger areas such as Upper Lip, or Bikini line .
t Switch Controls;
Power switch turns unit on/off.
Mode switch changes Mode from B = Body Mode to F = Face Mode
LEDs:
B = Body Mode - Yellow LED. F = Face Mode - Yellow LED. c = Contact = Green LED. o = On - Red LED
t ttoldmg e- o 1: You can hold e -SMOOTH in either hand like a pen or between f inger and
thumb. Howe ver · the silver conductive band needs to be in contact with skin at all times.
t Treatment;
Insert Roller Tip most suitable for intended treatment area.
Turn Power on and red LED will come on and Face mode will be se lected . If you require Body Mode
slide mode switch so B LED lights up.
Roller Tip must make contact with skin within 10 seconds otherwise unit will auto switch off.
Place Roller Tip on area to be treated and
1 bleep will sound indicating good
contact arid start of treatment cycle. c
Green contact LED will light up and Blue
LED's around Roller Tip light up during
treatment and flash during rest period.
After Tre tment. At the end of each
treatment cyc le 3 bleeps will sound and
unit will switch off. Apply your normal .
moisturizer as electrolysis can dry out
sk in .
DO NOT EXCEED RECOMMENDED
TREATMENTS!
ON/OFF Switch ---
Interchangeable Roller Tips (Large)
7
Conductive Band
Battery Compartment
(end ot wand unscrews)