VERTEX VD 26 SERIES
USER MANUAL
The Vertex VD series Temperature Controllers are a “Low Cost” Digital alternative to analog
controllers
, designed for use in simple applications where three term (PID) control is not required.
It
comes from the factory with default settings making it an “on/off” controller but can be user configured to have
proportional action “proportional”. It has a single digital display allowing access to all the parameters including
the “Process Variable” and “Set Point”. It is fully configurable on input including PT100 (RTD).
There are three simple steps required to get you up and running:
1. Installation 2. Wiring 3. Commissioning
Installation
Select the panel cut-out sizes from the table depending on the Model VD controller you have chosen and install
the controller accordingly in your panel.
■PANEL CUTOUT：
B
A
Model A B C D E a b c d
VD-2600
48 48 6 100 45 45+0.5 45+0.5 60 48
VD-2601 72 72 9 80 67 68+0.5 68+0.5 90 72
VD-2603 96 48 9 80 45 92+0.5 45+0.5 48 120
VD-2604 96 96 10 80 91 92+0.5 92+0.5 120 96
Wiring
■WIRING DIAGRAM：
1
To Next Page
Need help?
General
