EasyManua.ls Logo

Vespa 150 - Vespa 150 Decarbonization and 3000;6000 Km Service; Engine Decarbonization Procedure

Vespa 150
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7) - Clean the silencer and decarbo-
nize the engine as explained hereunder.
Remove the silencer, the cooling hood,
the cylinder head and the cylinder.
Decarbonize the piston crown and the
cylinder ports. Decarbonize the inner si.
de of the cylinder head. Clear carefully
the cylinder from carbon deposits.
Heat and clean the exhaust pipe of the
silencer, either by scratching it inside
with a hook wire or blowing air through
from the other orifice; in both cases the
silencer should be held so that the
exhaust pipe is turned downwards.
r...
Every 3000 Kms. (1800 miles): Grease
the felt which lubricates the cam of
flywheel magneto. Visit your Agent in
case of damper troubles.
Every 6000 Kms. (3600 miles):
Lubricate the speedometer drive pinion
and flex drive.
Battery service. Follow the directions
on the card accompanying each bat.
tery for service and normal re.charge.
Disuse: In such a case, proceed as follows.
1. Clean the scooter thoroughly (see
page 26).
2. Remove the air cleaner, start the
engine and run it at low revs in
neutral. Let the engine suck in 60 cc.
of oil ESSOLUBE 30 through the car-
burettor intake.
3. Rest the floorboard on two wooden
blocks in order to take weight off
the tyres.
4. Drain all fuel from both tank and
carburettor.
5. Grease all unpainted metal parts.
6. Disconnect the cables from the
battery; clean the terminals of the latter
and wipe dry.
-- 29

Other manuals for Vespa 150

Related product manuals