8
3. Set
When the lid is open, press this button to change between the
vacuum, gas, seal, or cooling time. Press the button “
∧” or “∨”
to increase or decrease each setting.
Note: There is no Gas option on the C25v at this time.
4. Vacuum Gauge
Shows the vacuum level inside the vacuum chamber.
5. Indicator light
When the lid is open, the indicator light references the setting
displayed on the LED display.
Note: There is no Gas option on the C25v at this time.
During operation, the indicator light flashes when that process
is active.
6. LED Display
1. Shows the vacuum/seal/cooling time depending on the
operation or setting being adjusted.
2. If the lid is closed and no operation is engaged, it will display
“CLO”.
7. Adjusting buttons Up and Down (“∧” “∨“)
When the lid is open, press the button “∧” or “∨” to adjust the
value for each setting.
To Next Page
Loading...