Vestfrost basic 2 induktion - Hob Operation Guide; Hob Power On and Off; Hob Cooking Zone Usage

7
OPERATION OF THE APPLIANCE
Use the induction cooking zones with suitable cookware.
After mains voltage is applied, all displays are come on for a moment. When this
time is over, the hob is in the stand-by mode and it is ready for operation.
The hob is controlled with electronic sensors which are operated by touching the
related sensors. Each sensor activation is followed by a sound signal (buzzer).
Switching the appliance on:
Switch the hob on by touching ON/OFF key . All heater displays show a static
0 and the bottom right dots blink. (If no cooking-zone is selected within 20
seconds, the hob will automatically turn off.)
Switching the appliance off:
Switch the hob off at any time by touching .
ON/OFF key has always priority in the switch off function.
Switching the cooking-zones on:
Touch the heater selection key you wish to cook on.Than you can adjust the
setting with the Plus/Minus key.The corresponding 7 segment display
is brighter and the decimal dot shows the selected cooking zone.
The element is now ready to cook on. For quickest boil times, select 9 and then
adjust down to a lower setting as required.
Switching the cooking-zones off:
Select the element you want to switch off by pressing the heater selection key.
Using key, turn the temperature down to 0.
If the cooking zone is hot, H will be displayed instead of 0.
+
/