● Check the hose for blockage.
● Check the hose for leaks by lifting each section
above water while pump is running.
●Check the diaphragm for blockages, and clean
and empty it if blocked. Noted that if too many
chemical tablets are used, the service life of
diaphragm will be shorter.
Cleaner gets
stuck on
steps.
● Adjust the return jets toward the problem area
to guide the cleaner away from the steps.
● Verify proper hose length.
● Ensure cleaner sits flush with the pool floor.
Adjust the position of hose weight if
necessary. This should be done at the deepest
part of the pool.
●
Increase or decrease the flow to your cleaner
via the regulator.
●Check the Mat for wear.
Cleaner
travels in a
repetitive
pattern.
● Adjust return jets downwards.
●
Verify proper hose length.
●
Ensure cleaner sits flush with the pool floor.
Adjust the position of t h e hose weight if
necessary.
●
This should be done at the deepest part of the
pool.
●Remove or add one hose section.
●
Inspect the Regulator Valve and flush away any
debris build- up.
●
Check that the hose sections are straight; if
not, lay hose in a straight line in the sun to
relax the memory.
To Next Page
Loading...