VEVOR 18151BX - Cleaner climbs out of pool and draws in air; Cleaner hose is tangling; Cleaner wont leave edge or rim

- 13 -
●
Twist each hose section a half- turn at each
connection point.
●
Ensure the wheel at the top of the Cleaner head
is rotating freely.
Cleaner
climbs out
of pool and
draws in air.
●Ensure there is a valve installed in the
skimmer/ weir.
●
Inspect the Regulator Valve and flush away any
debris build- up.
●
Verify proper hose length.
●
Ensure cleaner sits flush with the pool floor.
Adjust the position of hose weight if necessary.
This should be done at the deepest part of the
pool.
Cleaner hose
is tangling.
●
Ensure the wheel on top of the Cleaner body
is rotating freely and is screwed on securely.
●
Check that the hose sections are straight; if
not, lay t h e hose in a straight line in the sun.
●
There may be too many hose sections for
your pool. Try removing a section.
●
Inspect the Regulator Valve and flush away any
debris build- up.
●
For pools where the skimmer is located at one
end, the performance of the cleaner can be
greatly improved by tying the hose off in the
middle of the long side of your pool. This will
allow the cleaner to move about the entire pool
and eliminate the cleaner hose from tangling.
Cleaner
won't leave
edge or rim
●
Utilize return jets to move cleaner.
●
Adjust hose weight.
●
Try decreasing the flow to your cleaner via the
regulator. Less suction will allow the cleaner to