VEVOR 18151BX - Cleaner leaves patches; Cleaner sticks on walls and floors; Cleaner not sitting flat on bottom

- 14 -
of the pool.
move more freely.
Cleaner
leaves
patches.
●
Ensure the wheel on top of the Cleaner body
is rotating freely and is screwed on securely.
●
Adjust return jets downwards.
●
Verify proper hose length.
●
Ensure cleaner sits flush with the pool floor.
Adjust the position of hose weight if
necessary. This should be done at the deepest
part of the pool.
●
Check that the hose sections are straight; if
not, lay t h e hose in a straight line in the sun.
Cleaner
sticks on
walls and
floors.
● Ensure there is a valve installed in the skimmer
/
weir.
●
Inspect the Regulator Valve and flush away any
debris build- up.
● Check the Mat for wear.
●
Try increasing or decreasing the flow to your
cleaner via the regulator.
Cleaner not
sitting flat on
bottom.
●Ensure there is a valve installed in the skimmer
/
weir.
●
Inspect the Regulator Valve and flush away any
debris build- up.
●
Ensure the wheel on top of the Cleaner body
is rotating freely and is screwed on securely.
●
Adjust return jets downwards.
●
Verify proper hose length.
●
Ensure cleaner sits flush with the pool floor.
Adjust the position of hose weight if necessary.
This should be done at the deepest part of the
pool.