VEVOR B30B - Troubleshooting

- 8 -
TROUBLE SHOOTING
Trouble
Probable cause
Remedy
The mixing shaft don’t
rotates after switch on
Electric connectors are
loose
Check he electric
circuit, tighten those
loose connectors
Oil leakage
Oil seals are worn out
Replace those oil
seals
The raising handle is
too tight
Guide ways are
corroded
Clean and oil the
guide ways
The lead screw, bevel
gear and hand wheel
shaft etc is dry
Oil them
Temperature rise of
motor is too high, below
speed
Lack of voltage
Check the supply
voltage
Over load
Less load
The working speed
selected is too high or
agitator is not suitable
Select a suitable
speed and agitator
The noise of the
gearbox is serious, its
temperature is too high
Lubrication is
insufficient
Add or replace the oil
The agitator knocks
with the bowl
The agitator or the bowl
is deformed
Repair or replace
deformed part