Notice：Before installing the piston, O-ring for piston, beater and gasket for
beater, you should lubricate vaseline (lubricating vaseline onto the groove
of the gasket, do not onto the beater’s end ), using the vaseline frequently
can extend the service life of components.
B、Cleaning Machine Cabinet
Keep the machine cabinet clean, use wet towel to clean the cabinet, and
do not flush the machine with water directly.
C、Cleaning Condenser
After be used over a period of time, the condenser maybe thick with dust,
and this will effect radiate heat and cause refrigeration difference, so it
needs periodic cleaning (every half year)
Cleaning methods:
Step 1: Disconnected the main power switch.
Step 2: Remove the back panel and side panels.
Step 3: Clean dust with tools such as vacuum cleaner, high-pressure air
and hairbrush, be careful while cleaning to avoid damaging the fins of the
condenser.
D、Belt Adjustment
After be used over a period of time, the belt of the machine maybe
elongated, so it needs to be adjusted. Disconnected the main power of the
machine, remove the back panel and side panels, adjust the tension bolt
and make sure the belt is in appropriate tension.
To Next Page
Loading...
