j) Use extra caution when making a “pocket cut” into existing walls or other blind areas.
The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause
kickback.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
INSTALLING/REMOVING A DISC
WARNING: Always disconnect the machine
from the power supply before attempting to
install or remove a Cutting Disc.
• Ensure that the machines arbor and the
blade flanges are clean and free from dust and
debris.
• Ensure that the direction of rotation marked
on the blade matches the direction of rotation
marked on machines guard.
Note: this machine is supplied with
Note: The arbor bolt has a left hand
thread .Turn counter clockwise to tighten the
arbor . turn clockwise to loosen the arbor bolt.
To remove a cutting disc ,reverse the above
installation procedure.
To Next Page
Loading...
