CUTTING ADVICE
PRE-CUTTING ADVICE
• Ensure that the power supply matches the
requirements specified on the matches the
requirements specified on the machines rating
plate.
• Ensure that the machine trigger switch is in
the “OFF” position. If the machine is connected
to a power source with trigger switch the
“ON”position , the machine could start
operating immediately with the possibility of a
serious accident occurring.
• If an extension cable is required it must be a
suitable type for use outdoors and so labeled.
• The manufacturers instructions should be
followed when using an extension cable.
• Route any extension cable so that it does not
pose a trip (or any other ) hazard to the
operator to any bystanders.
WHEEL GUARD ADJUSTMENT
The wheel guard is adjustable and should be
positioned to provide the operator with the best
combination of personal protection and
visibility of cutting area.
• L oosen the wheel gard locking knob and
rotate the guard to the required
position.(FIG.6)
• Securely tighten the wheel guard locking
knob to lock the guard in place.
Note: the tightness of this locking knob and
the security of the wheel guard should be
checked regularly when operations
commence.
To Next Page
Loading...
