j) Use extra caution when making a “pocket cut” into existing walls or other blind areas.
The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause
kickback.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
INSTALLING/REMOVING A DISC
WARNING: Always disconnect the machine from the
power supply before attempting to install or remove a
Cutting Disc.
• Ensure that the machines arbor and the blade flanges
are clean and free from dust and debris.
• Ensure that the direction of rotation marked on the
blade matches the direction of rotation marked on
machines guard.
Note: this machine is supplied with
Note: The arbor bolt has a left hand thread .Turn
counter clockwise to tighten the arbor . turn clockwise
to loosen the arbor bolt.
To remove a cutting disc ,reverse the above installation
procedure.
To Next Page
Loading...
