USING A DUST EXTRACTION MACHINE
A workshop dust extraction manchine can be attached
to disc cutter.
WARNING:Dust can be very dangerous.We strongly
recommend that a suitable dust extraction machine (not
supplied) is used with this machine to keep the
workplace as clean and safe as possible.
The sucition hose from the dust extraction machine
should be attached to dust extraction port of the disc
cutter.
• Remove the rubber cap from the dust extraction pord
and store it safely for future use .
• Push the connection hose from the dust extraction
machine into the dust extraction port of the disc
cutter(FIG.4)
• Follow all instructions supplied with the dust extraction
machine when using such with the Disc cutter.
• Ensure that the hose and power cable of any attached
dust extraction machine do not pose or cause a trip or
any other from of hazard to the operator.
• when the dust extraction machine is no longer
required remove it from the disc cutter and replace cap
to the dust extraction port.
THE ON/OFF TRIGGER SWITCH
This machine is equipped with a safety start trigger
switch.
To start the tool:
• Push in the safety lock button (Fig.5a) on the side of
the handle with your thumb.
• Depress the main trigger switch (Fig.5b) to start the
motor.
WARNING: Never start the saw with the cutting edge of
the saw blade in contact with the workpiece surface.
To Next Page
Loading...
