CUTTING ADVICE
PRE-CUTTING ADVICE
• Ensure that the power supply matches the
requirements specified on the matches the
requirements specified on the machines rating plate.
• Ensure that the machine trigger switch is in the “OFF”
position. If the machine is connected to a power source
with trigger switch the “ON”position , the machine could
start operating immediately with the possibility of a
serious accident occurring.
• If an extension cable is required it must be a suitable
type for use outdoors and so labeled.
• The manufacturers instructions should be followed
when using an extension cable.
• Route any extension cable so that it does not pose a
trip (or any other ) hazard to the operator to any
bystanders.
WHEEL GUARD ADJUSTMENT
The wheel guard is adjustable and should be positioned
to provide the operator with the best combination of
personal protection and visibility of cutting area.
• Loosen the wheel gard locking knob and rotate the
guard to the required position. (FIG.6)
• Securely tighten the wheel guard locking knob to lock
the guard in place.
Note: the tightness of this locking knob and the security
of the wheel guard should be checked regularly when
operations commence.
To Next Page
Loading...
