apply these additional markings, where
[For products eligible to bear the cCSAus Mark, (i.e., the product is certified and
manufactured to the requirements of BOTH Canadian and U.S. Standards), the Markings
section of the report shall include the following statement:]
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and
'US' for Canada and US (indicating that products have been manufactured to the
requirements of both Canadian and U.S. Standards) or with adjacent indicator 'US' for US
only or without either indicator for Canada only.
applicable, in accordance with the requirements of those authorities.
Tools shall be marked with:
- The submittor's name and/or master contract number “300374”, adjacent to the CSA
Monogram with the C US Indicator;
- model or type reference;
- Rated voltage(s) or rated voltage range(s), in volts;
- Symbol for nature of supply, unless the rated frequency is marked;
- Rated input, in watts or rated current, in amperes;
- name or trade mark or identification mark and address of the manufacturer or any other
agent
responsible for placing the tool on the market;;
- Any mandatory mark showing compliance with legislation by reference to this standard.
- "WARNING: To reduce the risk of injury, user must read instruction manual. «MISE EN
GARDE – Pour réduire le risque de blessures, l’utilisateur doit lire le manuel d’instructions»
or equivalent or symbol M002 of ISO 7010
- M002 of ISO 7010
- date of manufacture.
-rated speed in revolutions per minute;
-rated capacity in mm;
-tools provided with a threaded spindle shall be marked with spindle thread size;
-WARNING Always wear eye protection, “AVERTISSEMENT Toujours porter des lunettes
To Next Page
Loading...
