Issue 5:Acidic /alkaline water or purified water does come out.
Solution:Please replace the water filters if needed.If water pressure is too
LOW,please increase it.If "cleaning indicator"light is "ON",please initiate
cleaning cycle.
Issue 6:There is some white sediment in the alkaline water.
Solution:The alkaline water after the production is usually whitish color,this
is normal and the water is OK to drink.
Issue 7:A white film appears on the inner wall of the alkaline water
container.Solution:This is a crystallization of calcium carbonate by gas in
the air after the reaction of solid components of calcium.These white
substances are normal when generating alkaline water.It does not imply
there is anything wrong with the water.The water is OK to drink.
Note:If this condition persists,please use food grade citric acid to clean the
plates or white vinegar.Allow the machine to soak for a few hours and flush
thoroughly.Please see maintenance procedures.
Note:If the machine will not be used for a long period,please unplug the
power cord,remove the filter and remove the Water Converter and water
purifier.Drain thoroughly and place the filter in a sealed plastic bag and
store in the refrigerator.
Issue 8:Alkaline water output amount reduces gradually.
Possible causes and solutions:
Inlet Water Pressure-make sure input water pressure is sufficient -above
40 psi.Filter blockage -please make sure filter life is OK and replace filters
as needed.Excessive build up of calcium deposits in the outlet tube -please
clean the out let tube as needed.Soak in vinegar as needed.
Excessive build up of calcium deposits on the electrolysis plates -please
contact customer service for support.
Made In China
To Next Page
Loading...