1. Occasional cleaning with mild soap and water along with light oil
lubrication of pivot points will prolong peak performance and
appearance.
2. Periodically check whether the screws are loose.
3. Before each use, inspect jack tubes and replace if bent or damaged.
4. If wiring is connected to battery terminal, inspect at least twice each
year for corrosion. Clean with a solution of baking soda and water,
and then apply a thin coat of grease.
5. The motor’s ground screw and mounting bolts must be cleaned if a
grounding continuity problem occurs.
6. Maintain the product by adopting a program of conscientious repair
and maintenance in accordance with the following recommended
procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep
handles dry, clean, and free from oil and grease. The following chart is
based on a normal operation schedule.
To Next Page
Loading...
