INSTALLATION
1. Unpack and takeout the product to see if the components are
：
Extension pole
with handle*1
；
Extension pole*6
；
Connecting pole*1
；
Saw handle*1
；
Saw blade*1
；
Portable bag*1
；
User manual * 1.
2. First, take off the hexagon screw and bolt from the
saw handle’s red steel tube with internal hexagon
wrench.
3. Put the saw blade into the Saw handle
，
align the two
holes, and tighten the screws.
4. Connect the extension poles sections② as length
requirement, lastly connect the extension pole with
handle
①.
5. Complete assembly.
ATTENTION MATTERS
1. The saw blades are sharp, so be careful when installing and using.
2. This product is made of assembled multi-section aluminum pole. It is not
recommended to do destructive product test to prevent the extension pole
connector fracture.
3. When installing the saw, it is necessary to ensure that all screws are tightened
to prevent the saw blade loosening and causing accidents.
4. After using the product, it’s better to disassemble and store it cleaning and
safely.
5.There may be a certain bending after extending the telescopic pole horizontally.
This is a normal phenomenon of this kind of product, not a quality problem.
To Next Page
Loading...