VEVOR SX-2A - Motor Slow or Noisy Operation; Motor Overheating; Spark on Carbon Brush Surface

- 13 -
Motor run slowly,or not
runs, even
vibrates,making noise.
Stuck inside of crush
cabin by material, or
foreign subject.
Remove the stuck stuff.
Low power voltage.
Insert the plug directly wall socket
instead of the terminal block. Then
try another place to see if the
machine can be turned on.
Motor cabin over heat.
Over load capacity.
Reducing the amount of grinding
and decreasing the working
pressure.
Material not dry
enough.
Dry the material in the sun or bake
it.
Low power voltage.
Insert the plug directly into the
wall socket instead of the terminal
block. Then try another place to
see if the machine can be turned
on.
Spark on the carbon
brush surface.
Carbon brush is not
smooth.
Change the carbon brush.
ENVIRONMENTAL PROTECTION
This product is subject to the provision of European Directive 2012/19/EC.
The symbol showing a wheelie bin crossed through indicates that the product
requires separate refuse collection in the European Union. This applies to the
product and all accessories marked with this symbol. Products marked with
this symbol cannot be discarded with normal household waste but must be
taken to an electrical and electronic equipment collection point for recycling.