TECHNICAL SPECIFICATIONS
Accurate LED display in 0.1 degree increments.
- 1 degree increments for temperature setting.
- Max Load: 1000 Watts.
- Max Amps: 8.33A.
- 120V input &output voltage.
- Temperature control range: 40-108℉(5-42℃)
-Temperatre display range: 32-140℉(0-60℃)
- Save current program after power off.
- Includes power and load indicators.
- Includes 3 grounded power plugs.
ABNORMAL WARNING
If thermostat shows
- 'E1': the actual temperature is lower than 32℉ or 0℃
- 'E2': the actual temperature is higher than 108℉ or 60℃
- 'E3: the temperature sensor is not working properly
TROUBLE SHOOTING:
HEAT MAT IS NOT REACHING SET TEMPERATURE?
Standard heating mats will not fully heat a lot of tanks in the market. The heat mat itself does not have supply
enough power to heat the entire tank.The temperature probe is reading the temp at the probe, and adjusting to
that. You should tape the probe directly to the "Under Tank Heater (UTH)", then set the temperature however
high you need it to get the bottom of the cage to the appropriate temp. Just some insight, a heat mat is only
really good for belly heat and won't raise the ambient temps much.This is not the thermostat malfunctioning.
To Previous Page
Loading...
