2. Place the untrimmed plants on the grill.
3. Place the top and handle back on the base.
4. Turn the handle clockwise for about 15-30 rounds.
Using the handle, make 15-30 complete
turns. While spinning the handle, the inside
rubber twist tongues multiply the rate of the
spinning plants and blades by over 30
times. A combination of the rubber tongues
presses and rolls the plants into the
spinning blades can improve the cutting
efficiency. Only 30 seconds can yield one
hour's work.
Place the untrimmed plants on top
of the grill. The plans should be
enough to make sure the grill
surface is covered(approximately
40 dry grams)
To Next Page
Loading...
