VEVOR 0700C User Manual

Support and E-Warranty Certificate https://www.vevor.com/support
ELECTRIC TRIMMER
USR MANUAL
MODEL:0700C
We continue to be committed to provide you tools with competitive price.
"Save Half", "Half Price" or any other similar expressions used by us only represents an
estimate of savings you might benefit from buying certain tools with us compared to the major
top brands and doses not necessarily mean to cover all categories of tools offered by us. You
are kindly reminded to verify carefully when you are placing an order with us if you are
actually saving half in comparison with the top major brands.

VEVOR 0700C Specifications

General

Model	0700C
Blade Material	Steel
Engine Type	2-Stroke
Engine Displacement	25.4 cc
Shaft Type	Straight
Starter Type	Recoil
Power Source	Gas Powered

Summary

Electric Trimmer Technical Specifications

Component Overview

Details the main parts of the electric trimmer, identified by numbers.

General Safety Instructions for Electric Trimmer

Work Area Safety Guidelines

Guidelines for maintaining a safe and clean work environment to prevent accidents.

Electrical Safety Precautions

Precautions regarding electrical connections, cords, and protection against shock.

Personal Safety Measures

Advice on staying alert, using common sense, and wearing protective gear.

Machine Use and Care Procedures

Instructions on proper operation, maintenance, and care of the machine to ensure safety.

Machine Service and Maintenance

Information on maintaining the machine, replacing parts, and contacting VEVOR for repairs.

Electric Trimmer Operation Instructions

Adjusting Bit Protrusion

Steps to loosen the locking lever and adjust the tool base for bit protrusion.

Switch and Power Control

How to start and stop the electric trimmer using the ON/OFF switch.

Variable Speed Adjustment

Guidance on adjusting the tool's speed using the dial from 1 to 6.

Installing and Removing Trimmer Bits

Procedure for inserting and removing bits using the collet nut and shaft lock.

Using the Straight Guide

Using the straight guide for straight cuts, chamfering, or grooving.

Performing Circular Cuts

How to perform circular cuts using the straight guide assembly.

Using the Trimmer Guide

Using the trimmer guide for trimming and curved cuts in veneers.

Preventing Motor Overload

Warning about motor damage from excessive pressure and how to avoid it.

Replacing Carbon Brushes

Procedure for checking, replacing, and maintaining carbon brushes.

Trimming Base and Dust Collector Setup

Instructions for attaching the dust collector and preparing the machine base.

Engraving Machine Operation Mode

Safe Tool Handling for Engraving

Important safety advice for holding the tool tightly with both hands when used as an engraving machine.

Depth Adjustment and Accessory Setup

Base Adjustment and Depth Setting

Steps to adjust the tool base, set depth pointer, and lock the fuselage.

Installing the Straight Guide

Procedure for installing the straight guide to the guide bracket using butterfly nuts.

Using the Linear Guide

Using the linear guide plate for oblique planing or slotting with linear cutting.

Sample Gauge Guide Plate Installation

Instructions for installing and using the sample gauge guide plate for specific cutting modes.

Operating with Sample Gauge

Fastening the sample gauge and moving the tool along its guide plate.

Calculating Cutting Distance

Notes on workpiece cutting size variation and calculating cutting distance (x).

Cut-in Base and Dust Collection

Instructions for installing the dust collection port using butterfly screws.