Maintain machines. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the
machine’s operation. If damaged, have the machine repaired before
use. Many accidents are caused by poorly maintained machines.
Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to
control.
Use the machine, accessories and tool bits, etc., in accordance with
these instructions and in
The manner intended for the particular type of machine, taking into account
the working conditions and the work to be performed. Use of the machine
for operations different from intended could result in a hazardous situation.
Keep handles and grasping surfaces dry, clean and free from oil and
grease. Slippery handles and grasping surfaces do not allow for safe
handling and control of the tool in unexpected situations.
5) Service
Have your machine serviced by a qualified repair person using only
identical replacement parts.
This will ensure that the safety of the machine is maintained.
Maintain labels and nameplates on the tool. These carry important
safety information. If unreadable or missing, contact VEVOR for a
replacement.
Type Y attachment: If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Adjust bit protrusion
1b adjust the bit protrusion, loosen the locking lever and move the tool
base up or down as desired by turning the,adjusting screw. After adjusting,
tighten the locking lever firmly to secure the tool base.
To Next Page
Loading...
