VEVOR 0700C - Cut-in Base and Dust Collection

- 18 -
For cut in base(optional accessories)
1.Dust collector
2. Butterfly screw
Use the dust collector to remove dust.Use butterfly screws to install the
dust collection port on the tool base,so that the convex part on the dust
collection port is embedded in the groove on the tool base. Then,connect
the hose of the vacuum cleaner to the dust collection port.
Standard configuration
 6.35mm milling cutter
 8mm milling cutter
 Guide as-straight
 Guide as-finisher
 Trimming machine base assembly
 13 wrench
 22 wrench
 6.35mm tapered collet
 8mm tapered collet
Purchase accessories
 Tilt base assembly
 Cut in base assembly
 Offset base assembly
 6mm tapered collet
 9.53mm tapered collet