To replace the battery, turn off the transmitter and then disconnect the
transmitter from any cable/lead and circuit. Remove the screw on the
battery cover of the transmitter and then remove the battery cover.
Replace the old battery with a new one of the same type, make sure
that the polarity connections are correct. Reinstall the battery cover and
the screw.
Warning
To avoid electric shock, turn off the transmitter and then disconnect
the transmitter from any cable/lead and circuit before opening the
battery cover or case of the transmitter.
Replacing the battery in the receiver:
When the low battery indicator " " appears on the receiver
display, the battery in the receiver is not high enough and you must
replace it immediately; otherwise the receiver will not operate normally
or the detection result may be wrong.
To replace the battery, turn off the receiver first. Remove the screw on
the battery cover of the receiver and then remove the battery cover.
Replace the old battery with a new one of the same type, make sure
that the polarity connections are correct. Reinstall the battery cover and
the screw.
The fuse in the transmitter protects the transmitter against overload
or faulty manipulation.
If the output signal generated by the transmitter is weak and can not
be increased to a normal level, the fuse in the transmitter may be
damaged.
REPLACING THE FUSE IN THE TRANSMITTER
To Next Page
Loading...
