To Next PageTo Next PageWhat to do if my VEVOR Pressure Washer does not start?
If your VEVOR Pressure Washer isn't starting, the possible causes and solutions are: * The battery pack may not be installed correctly, so try reinstalling it. * The battery pack might be dead; in this case, charge it or replace it with a new one. * The battery pack could be broken, requiring a replacement.
Why does my VEVOR XS-003 automatically stop?
Your VEVOR Pressure Washer might automatically stop because: * The battery pack is dead: Charge or replace the battery pack. * The gun head is blocked, triggering current protection: Clear or replace the head.
How to fix VEVOR Pressure Washer when it's not sucking water?
If your VEVOR Pressure Washer is running but not sucking water, consider these potential causes and solutions: * If the machine is more than 1.5 meters above the water source, lower it. * A clogged filter screen: Remove the filter and clean it. * A failure of connection of the intake pipe to the machine or a rupture of intake pipe: Check and replace water pipes,please contact customer service. * A bent intake pipe: Straighten out the intake pipes and reconnect them. * A frozen pump due to cold weather: Restart the machine after thawing.
What to do if my VEVOR Pressure Washer has discontinuous pressure?
If your VEVOR Pressure Washer has discontinuous pressure, it could be due to: * Air in the pump: Check that joints and pipes are in good condition. * The machine being in low voltage mode: This is normal at low pressure and requires no treatment.
Why is my VEVOR XS-003 battery pack not charging?
If your VEVOR Pressure Washer battery pack is not charging, it might be due to a charger mismatch or the charger being broken. In this case, replace it with a matching charger.
What to do if there's a sudden pressure increase or abnormal water from my VEVOR Pressure Washer?
If you notice a sudden increase in effluent pressure or abnormal water type from your VEVOR Pressure Washer, it could be because the head of the water gun is blocked by a foreign object. Try using a needle to clear the nozzle or replace the gun head.
General| Maximum Pressure | 3000 PSI |
|---|---|
| Flow Rate | 2.4 GPM |
| Power Source | Gasoline |
| Engine Type | 4-Stroke OHV |
| Engine Displacement | 196 cc |
| Nozzles Included | 5 (0°, 15°, 25°, 40°, Soap) |
| Hose Length | 25 feet |
