D
dblackSep 8, 2025
What to do if the choke lever is in the choke position on a hot engine of my VEVOR G250A Pressure Washer?
- DdavidpierceSep 8, 2025
Move the choke lever to the NO CHOKE position on your VEVOR Pressure Washer.
To Next PageTo Next PageWhat to do if the choke lever is in the choke position on a hot engine of my VEVOR G250A Pressure Washer?
Move the choke lever to the NO CHOKE position on your VEVOR Pressure Washer.
What to do if there is air in the hose of my VEVOR G250A Pressure Washer?
Turn off the engine and the water source. Disconnect the water source from the pump inlet, then turn the water source on to remove air from the hose. When a steady stream of water is present, turn the water source off. Reconnect the water source to the pump inlet and turn on the water source. Squeeze the trigger to remove any remaining air.
What to do if the water filter screen is clogged in my VEVOR G250A Pressure Washer?
Remove and clean the water filter screen of your VEVOR Pressure Washer.
What to do if my VEVOR G250A Pressure Washer has low oil?
Add the required amount of oil to your VEVOR Pressure Washer.
What to do if the chemical filter is clogged in my VEVOR G250A Pressure Washer?
Clean the chemical filter of your VEVOR Pressure Washer.
What to do if there is a loose hose connection on my VEVOR Pressure Washer?
Tighten the loose hose connection on your VEVOR Pressure Washer.
What to do if the vent plug is clogged on my VEVOR Pressure Washer?
Clean the vent plug by blowing air through it to remove any blockage. If the problem persists, replace the plug on your VEVOR Pressure Washer.
What to do if pressure builds up after two pulls on the recoil starter of my VEVOR G250A?
Squeeze the gun trigger to relieve the pressure on your VEVOR Pressure Washer.
What to do if water is leaking at the pump of my VEVOR G250A Pressure Washer?
Tighten the connection where water is leaking at the pump of your VEVOR Pressure Washer.
What to do if the spark plug wire is not attached to my VEVOR Pressure Washer?
Attach the spark plug wire to your VEVOR Pressure Washer.
General| Brand | VEVOR |
|---|---|
| Model | G250A |
| Category | Pressure Washer |
| Language | English |
Indicates an imminent hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
Used without the safety alert symbol indicating potentially hazardous situation which, if not avoided, may result in property damage.
Details risks of ignition from gasoline vapors, fuel expansion, explosive environments, and overheating.
Covers risks from exhaust fumes and chemical cleaning fluids, with prevention methods.
Warns about contact with hot engine components and the risk of serious burns.
Addresses risks from using acids, toxic chemicals, or flammable solvents, and recommends protective measures.
Highlights dangers of improper operation, kickback, and misuse by children.
Warns about high-pressure fluid penetration, amputation risks, and proper handling of leaks.
Details risks from high-velocity spray, projectiles, and accidental operation.
Warns about fatal electrical shock from spraying electrical outlets or connected objects.
Explains how to adjust the pressure setting of the washer for optimal cleaning.
Guides on selecting and using the correct spray nozzle for different cleaning tasks.
Provides guidance on consulting the engine owner's manual for maintenance recommendations.
Details the procedure for checking the oil level in the pump.
Step-by-step instructions for draining and refilling the pump oil.
Addresses excessive pressure issues caused by clogged nozzles and how to clean them.
Instructions for periodically checking and cleaning the water inlet filter screen.
Provides guidance for storing the engine and pump components to prevent damage.
