61
Cable Storage & Cleats
Use the cable handle as
your cable storage and
the tie-down cleats on
either side to keep it in
place and out of your way.
Transducer Holder
Store the transducer in
the special holder above
the battery. The holder is
designed to accept most
styles of Ice-Ducers.
Battery Compartment
To remove the battery, remove the
flasher from the carrying case, then
the transducer holder by removing
the two mounting screws.
Easy Charge Jack
Charge the battery here.
Connect the Easy Charge
Jack to begin the charging
process. Be sure to
disconnect from the battery
when putting the system
away for more than a month,
but remember to re-connect
it before recharging once it
comes out of storage or the
battery will not receive
a charge.
Accessories
Use the pre-drilled holes for
Vexilar add-on accessories
such as the FlexLight.
See pages 70 & 71.
Eye-Bolt
Insert the transducer
support eye-bolt here,
or into the pack’s front
or far side. Be sure to
remove the float from the
transducer cable when
using the eye-bolt.
To Next Page
Loading...
Need help?
General
