10 11
Follow the CLEANING instructions, starting on page 8, when the humidifier will not
be used for at least one week or more, or at the end of the season.
At the end of the season, remove any accessories used with the humidifier and allow
to dry properly.
Dry the humidifier completely before storing. DO NOT store with water inside the
main housing water reservoir or water tank.
Pack unit in original carton and store in a cool, dry location.
Mail questions or comments to:
Kaz USA, Inc.
Consumer Relations Dept.
250 Turnpike Road, Southborough, MA 01772
TO ORDER REPLACEMENT PARTS CONTACT CONSUMER RELATIONS
Please be sure to specify model number.
Call us toll-free at: 1-800-477-0457
E-mail: consumerrelations@kaz.com
Or visit our website at: www.kaz.com
Consumer Relations
End-Of-Season Care And Storage
The Vicks V4600 Series model is rated at 120V, 60 Hz.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST
OR SEE YOUR WARRANTY. DO NOT RETURN THE HUMIDIFIER TO THE ORIGINAL PLACE
OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING OR TAMPER WITH
INTERLOCK SWITCH YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE
DAMAGE TO THE PRODUCT OR PERSONAL INJURY.
Electrical Ratings
ENGLISH
Troubleshooting
Solution
• Plug unit in
• Check circuits, fuses, test
outlet.
• Fill Water Tank.
• Place on a level surface.
• Clean nebulizer (refer to
Weekly Care & Cleaning
instructions on page 8)
• Rinse thoroughly with
clean water.
• Check the Tank for leaks
and replace if necessary
• Tighten Tank Cap
• Decrease mist output to
lower setting or open door
to the room.
If your humidifier is not working properly, refer to the following:
Problem
• Power Switch is set to “On”
and the nightlight is off
• Little or no mist is produced
• Water overflows from
Reservoir
• Condensation forms around
humidifier or windows
Possible Cause
• Unit not plugged in
• No power at outlet
• No water in tank
• Unit is not level
• Mineral deposits on
nebulizer
• Water Tank or Base were
washed with detergent
• Tank may be leaking
• Tank Cap is not tight
• Mist Intensity is set too
high for room size or
pre-existing humidity level.
NOTE: Failure to keep this unit clean from mineral deposits normally contained in any water
supply will affect the efficiency of operation of this unit. Customer failure to follow these
instructions may void the warranty.
To Next Page
Loading...
Need help?
General
