To Next PageTo Next Page
Need help?Do you have a question about the Vicon SurveyorVFT SVFT-M and is the answer not in the manual?
Explains safety symbols used in the manual.
Covers reading instructions, cleaning, attachments, and general precautions.
Details power sources, grounding, lightning, and object/liquid entry precautions.
Specifies when to seek qualified service and ESD precautions.
Specific safety guidelines for 230 VAC devices.
Alerts to RF energy and provides steps to correct interference.
Emphasizes power removal and static discharge precautions.
Guide on navigating and understanding the manual's structure and content.
Lists the main physical parts of the SVFT-M system.
Instructions for checking equipment upon delivery for damage.
Describes the main enclosure, mounting, and interface board.
Details the pan/tilt drive, camera, and CPU assembly.
Details the polycarbonate dome, trim ring, safety cord, and shroud.
Instructions to record MAC address and password for IP configuration.
Provides a step-by-step overview of the installation process.
Describes the overall mounting and cable routing for installation.
Explains how to connect relays and alarms.
Guides on routing and connecting cables to the interface board.
Outlines daisy-chain and star configurations for system setup.
Details connecting one dome to a PC for control and upgrades.
Guide to configuring the unit's address, mode, and protocol using DIP switches.
Instructions for setting up the IP version of the camera dome.
Explains user and group limitations in ViconNet software.
Steps to configure IP network parameters for the camera.
Details the Setup tab for upgrade files, log files, and password management.
Guide to selecting and authenticating IP units within VNSetup.
Instructions for installing/upgrading software versions.
Displays general information for the selected IP product.
Provides options for unit recovery, restart, and default settings.
Shows the typical screen display after ViconNet configuration.
Interface for modifying camera dome IP parameters and network settings.
Steps for powering up and verifying the initial operation of the SVFT-M.
Shows the main menu structure accessed via the keypad.
Procedures for testing functionality and auto-baud detection.
Lists protocols tested and required configurations for compatibility.
Instructions for cleaning the camera dome.
Details how to replace internal fuses.
Guidance on selecting appropriate coaxial cables for optimal performance.
Information on UTP receivers for video transmission.
Specifies the actual dimensions for standard 1.5-inch pipe.
Details electrical specifications like input voltage and power consumption.
Lists standard connector types and data transmission speeds.
Details preset, tour, alarm, and relay capabilities.
Information on screen titling, privacy masks, and control display.
General| Sensor Type | CCD |
|---|---|
| Focal Length | 3.6 mm |
| Power | 12VDC |
| Synchronization | Internal |
| Power Supply | 12VDC |
| Weight | 200g |
| Image Sensor | 1/3 inch |
| Signal to Noise Ratio | 48dB |
| Video Output | 1.0Vp-p, 75 Ohms |
| Operating Temperature | -10°C ~ +50°C |
