9
SAFETY TRAINING
certification. Weigh the tractor and equipment. Do not guess or estimate!
TRANSPORT SAFETY
Comply with state and local laws governing highway safety and movement of farm
machinery on public roads.
The use of flashing amber lights is acceptable in most localities. However, some
localities prohibit their use. Local laws should be checked for all lighting and marking
requirements.
At all times, when driving the tractor and equipment on the road or highway under 20
m.p.h. (32kph) use flashing amber warning lights and a slow moving vehicle (SMV)
identification emblem. Do not exceed 20 m.p.h. (32 kph). Reduce speed on rough
roads and surfaces.
Plan your route to avoid heavy traffic.
Always install transport locks, pins or brackets before transporting.
Do not drink and drive.
Be a safe and courteous driver. Always yield to oncoming traffic in all situations,
including narrow bridges, intersections, etc. Watch for traffic when operating near or
crossing roadways.
Turn curves or go up or down hills only at a low speed and at a gradual steering angle.
Make certain that a least 20% of the tractor’s weight is on the front wheels to maintain
safe steerage. Slow down on rough or uneven surface. Always check tractor manual
for proper use on slopes.
Use extreme care and maintain minimum ground and when operating close to ditches
or fences. Be careful when turning sharp corners.
Never allow riders on either tractor or wood chipper.
To Next Page
Loading...
Need help?
General
