16
OPERATION
MACHINE BREAK-IN
Although there are no operational restrictions on the Wood Chipper when used for the first time, it
is recommended that the following mechanical items be checked:
A. A
fter operating for 1 hour:
1. Torque all fasteners and hardware.
2. Check condition of rotor bearings.
3. Check the condition and clearance of the branch bearker, rotor and stationary blades.
Adjust or replace as required.
4. Check for entangled material. Remove all entangled material before resuming work.
5. Lubricate all grease fittings.
B. A
fter operating for 10 hours:
1. Repeat steps 1 through 5 listed above. (Section A)
2. Go to the normal servicing and maintenance schedule as defined in the Maintenanc
e
S
ection.
PRE-OPERATION CHECKLIST
Efficient and safe operation of the 3 Point Hitch Wood Chipper requires that each operator reads
and understands the using procedures and all related safety precautions outlined in this section. A
pre-operation checklist is provided for the operator. It is important for both the personal safety and
maintaining good m
echanical condition that this checklist is followed.
Before operating the Wood Chipper and each time thereafter, the following areas should be
checked off:
1. Lubr
icate the machine per the schedule outline in the Maintenance Section.
2. Check the rotor, blades and branch-breaker. Remove any twine, wire or other material that has
become entangled.
3. Check the condition and clearance of the branch breaker, rotor and stationary blades. Adjus
t
or
replace as required.
4. Check that all bearings turn freely. Replace any that are rough or seized.
5. Make sure that all guards and shields are in place, secured and functioning as designed.
6. Check the condition of the curtain in the feed hopper. It must be in good condition to prev
ent
c
hips from flying out.
To Next Page
Loading...
