To Next PageTo Next Page
Need help?Do you have a question about the Victory RS-2D-S7 and is the answer not in the manual?
General| Brand | Victory |
|---|---|
| Model | RS-2D-S7 |
| Category | Refrigerator |
| Language | English |
Examine shipment packaging for damage. Note damage on delivery slip and file a claim with the carrier.
Remove packaging material, skid bolts and skid. Never lay the unit down.
Consider clearance, floor load, and ventilation for optimal placement.
Screw in casters/legs by hand, then tighten with a wrench. Tilt cabinet to install.
Cabinets must be leveled for proper door sealing and drainage. Adjust legs or use washers.
Wash interior with mild detergent and water, rinse, and sanitize before use.
Insert shelf support clips into pilasters and rest shelves on clips.
Wiring by qualified electrician. Ensure proper voltage and ground wire.
Set temperature for refrigerators (38-40°F) and freezers (-3-3°F). Learn adjustments.
Verify electrical hook-up, refrigeration lines, condenser fan, and levelness before start-up.
Load food after reaching temperatures. Allow 1-1/2" clearance for efficiency.
Perform daily exterior cleaning and weekly interior cleaning as instructed.
Clean condenser every three months (monthly if near cooking equipment).
Motors are permanently lubricated. No oiling required for compressor, condenser, or evaporator motors.
Remove old gasket by prying loose. Replace by soaking in warm water and pressing into retainer strip.
Shows the electrical connections for 1, 2, and 3 section refrigerator models.
Displays the electrical wiring for 1 section freezer models.
Illustrates the electrical connections for 2 section freezer models.
Details the electrical wiring for 3 section freezer models.
