Advanced Preparations:
• Be familiar with the controls of the range hood by reading through Range Hood Operations.
•
standard outlet (please refer the product label for the suitable voltage of this unit) and turn
on the range hood. Verify all operations of the range hood by referring to Range Hood
verify the existence of all supplied parts.
• Carefully remove the white or blue plastic protective coat from the range hood.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
• Decide the location of the venting pipe from the hood to the outside. Refer to Venting Methods.
•
• Try to avoid as many transitions, elbows, and long run as possible. This may reduce the
performance of the hood.
• Using 45 degee elbows is better than using 90 degree elbows.
•
• Use aluminum tape to seal joints between pipe sections.
THE HOOD MUST BE TESTED BEFORE INSTALLATION.
PLEASE TEST THE RANGE HOOD FOR PROPER OPERATION BEFORE
BOXING IT, OR RECESSING IT INTO THE CEILING.
DO NOT CLOSE THE BOX AROUND THE HOOD UNTIL THE TEST HAS
BEEN PERFORMED.
Victory Range Hoods Inc. will not be responsible for additional labour costs related to
reinstallation of the hood due to transportation internal damage or wiring issues.
| TESNUS 11
PREPARATION
To Next Page
Loading...
