Victrola VBB-25 - Setup and Operation Guide; Basic Setup and Powering; Battery Handling and Disposal; Cassette Operation Guide

4
CASSETTE OPERATION
SET UP / BASIC OPERATION
BASIC SET UP
1. Plug the provided AC Power Cord into the back of the unit, then insert plug into the
nearest wall outlet. Note: The unit can also be powered by 4x C (UM2) batteries
(not included) by placing them in the battery compartment on the back of the unit.
2. The unit will automatically be in Cassette Mode.
3. Use the Function Switch on the top of the unit to switch between Tape, FM, AM, and Bluetooth.
4. Use the Radio Tuning Dial to manually adjust the Radio.
5. Use the Volume Knob to manually adjust the volume.
6. To use Headphones, simply plug headphones (not included) into the Headphone Jack on the
side of the unit. The built-in speaker will stop playing once the headphones are plugged in. Use
the Volume Knob to manually adjust the volume.
7. To turn off the unit, slide the function switch to TAPE/OFF.
Note: Make sure the cassette player is stopped.
BATTERY PRECAUTIONS
- Be sure to insert the battery in the correct positive “+” and negative “-” orientation.
- When using rechargeable batteries, refer to the precautions on their labels.
- Do not heat or disassemble batteries and NEVER dispose of old batteries by throwing in a fire.
- Do not dispose the batteries into standard garbage disposal sites. Dispose of the batteries at an
available Battery Recycling Site after fully discharging. No doing so may violate disposal laws and
regulations. Please refer to local regulations for proper battery disposal.
Slide the function switch to TAPE/OFF, then follow the steps below:
1. Press the STOP/EJ. button. Insert the cassette tape, bottom side up with the tape facing you.
Manually close the Cassette door.
2. Play - Press the PLAY BUTTON to start playing the tape.
3. Pause - Press the PAUSE button to stop the tape during recording or playback, press the pause
button a second time the resume play or recording.
4. Fast Forwarding and Rewind - To fast forward or to rewind the tape, press the F.FWD or
REW
button. Press the STOP/EJ. button to stop the tape at the desired location.
5. Automatic Stop (Auto Stop) - When the cassette tape that is being played or recorded
and reaches the end of the tape, it will automatically stop.
6. Recording - Install a cassette to record over. Press the REC button.
To record audio from another function, move the Function Switch to the desired position to record
audio in that mode.
MIC recording
Press the REC button in TAPE mode, the Built-in Microphone will record all audible content.
To stop recording, press the STOP/EJ. button. Rewind the tape to play back the recorded content.
The MIC recording can only perform in TAPE mode.