Need help?Do you have a question about the Victron energy Phoenix Smart IP43 12/30 and is the answer not in the manual?
General| Output Voltage | 12 VDC |
|---|---|
| Output Current | 30 A |
| Bluetooth | Yes |
| Input Frequency | 45-65 Hz |
| Protection | Over temperature |
| Battery Types | Lithium |
| Communication | Bluetooth |
Install the charger in a location with good natural airflow/ventilation and sufficient unobstructed space around it.
Install and charge the battery in a location with good natural airflow/ventilation.
Ensure that the DC system is fully shut down/isolated prior to disconnection of any existing cabling.
AC connection to the mains supply must be in accordance with local electrical regulations.
Refer to the battery manufacturers instructions and specifications to ensure the battery is suitable for use.
Intelligent multi-stage battery chargers, engineered to optimise each recharge cycle and maintenance.
Details how to wall mount the charger using flanges and required clearances for airflow.
Selection of suitably rated DC cabling, insulation, and fuse/circuit breaker for safe operation.
Details the 3 integrated charge modes (Normal, High, Li-lon) and optional Recondition stage.
Shows voltage settings for each charge stage based on selected charge mode.
Details the meaning of LEDs for operation states and error states.
How to monitor charger operation and statistics using the VictronConnect app.
Enables specific configuration of charge parameters and user defined settings to be saved.
To Next Page