Need help?Do you have a question about the Victron energy SmartSolar MPPT RS 450 100 and is the answer not in the manual?
General| Maximum PV Power (Nominal) | 4500 W |
|---|---|
| Maximum PV Open Circuit Voltage | 450 V |
| Maximum Charge Current | 100 A |
| Nominal DC Voltage | 12/24/48 V Auto Select |
| Battery Voltage Range | 8 - 70V |
| PV Input Voltage Range | 8 - 450V |
| Peak Efficiency | 99 % |
| Self Consumption | 10 mA |
| Operating Temperature Range | -40 to +60 °C |
| Bluetooth Built-in | Yes |
| IP Rating | IP43 |
| Operating Temperature | -40 to +60 °C |
| Communication | VE.Direct, VE.Can |
| Protection | PV Reverse Polarity / Output Short Circuit / Over Temperature |
Provides guidelines for selecting an optimal and safe installation location for the MPPT RS.
Specifies the necessary capacity and cable requirements for the battery system.
Guides on how to configure the controller using the VictronConnect app.
Details how to configure battery-related settings for optimal charging.
Provides step-by-step instructions for starting up and shutting down the unit.
Details the built-in protections and how the unit restarts after faults.
Offers guidance on how to troubleshoot issues and seek support.
Provides steps to diagnose why the controller is not powering up or operating.
Lists common reasons and solutions for batteries not charging.
Addresses scenarios where batteries are not sufficiently charged.
Discusses the dangers and causes of overcharging batteries.
Covers remaining potential issues related to solar power generation.
Addresses problems related to communication with other devices.
Addresses problems arising from incorrect settings or firmware.
Lists and explains various error codes that may be displayed by the unit.
To Next Page