2020-09-30 06:30 3/7 VE.Direct LoRaWAN module manual
Victron Energy - https://www.victronenergy.com/live/
Mount the LoRaWAN Module close to the device you wish to monitor2.
Connect the VE.Direct cable between devices3.
Connect the DC Power (8V - 68V, looking to the module with green connector below of the4.
module, the positive is on the left)
After a short wait the LED will blink green indicating that all is OK5.
Go to the VRM Portal to add your installation6.
Details
After power-up, the module will gather information from the VE.Direct device. Once received it
connects to the LoRaWAN network, and then sends all available data to the VRM Portal.
After this first transmission, it will send the most important data hourly:
BMV and SmartShunt Battery Monitor
Battery Voltage
Battery Current
Battery Power
State of Charge
Alarm status & reason
MPPT Solar Charger
Solar Power
Battery Voltage
Battery Current
Battery Power
Error code
Charge state (Off, Bulk, Absorption, Equalize, Float)
Phoenix VE.Direct Inverters
Battery Voltage
AC Output current
Alarm status & reason
Mode (On/Off/Eco)
Note that data may not always arrive at the VRM Portal every hour. Transmission over the air can fail -
even when your LoRaWAN device is mounted close to a gateway. This is normal and part of the
LoRaWAN concept.
LED Codes
LED Status Definition
———- ———-
Blinking blue
Connecting to LoRaWAN. If your module keeps blinking blue, check LoRaWAN
Network coverage.
Blinking green
Everything is OK and a connection has been made both to LoRaWAN and to the
VE.Direct device.
To Next Page
Loading...
Need help?
General