Videocon SPRING-WM VSP70LPW-SFK

Questions and Answers

R
Robin BakerAug 1, 2025
Why is my Videocon SPRING-WM VSP70LPW-SFK making excessive noise during spin?
- M
  Matthew WilliamsAug 1, 2025
  If your Videocon Washer is making excessive noise during spin, first ensure the machine is level and placed on a stable floor. If not, level the machine. Also check if the screws fixing the motor have come loose and fix them if necessary. Another cause might be clothes stuck between the tub and basket; remove them if present.
S
sanchezlouisAug 6, 2025
What to do if my Videocon SPRING-WM VSP70LPW-SFK Washer won't drain?
- J
  James FloresAug 7, 2025
  If your Videocon Washer is not draining or the draining doesn't stop, make sure the drain hose is lowered. Check the drain hose for lint accumulation, and clean or replace it if necessary. Inspect the Cock Rod A; replace or connect it if broken or separated. Also, check and adjust or replace the DV Bellow and D.V-spring if they are defective. Ensure the Guide-A.T is properly aligned and replace if defective. Lastly, make sure the lid is closed and the safety switch is properly adjusted or replaced if defective. A defective spin timer may also be the cause, in which case it should be replaced.
A
Anthony WolfAug 14, 2025
How to fix no agitation in Videocon SPRING-WM VSP70LPW-SFK Washer?
- A
  Allison CrossAug 14, 2025
  If your Videocon Washer shows no agitation or poor agitation, ensure the power plug is correctly inserted. Check for obstructions like clothes or objects stuck in the pulsator gap; remove the pulsator to check and clear any obstructions. Verify the pulsator screw is properly mounted and fix if defective. Adjust the belt tension if it is loose. Finally, if there is too much wash load, remove some clothes. If the motor, timer, or gearbox are defective, replace them.
J
jbrewerAug 19, 2025
What to do if spinning basket does not stop in Videocon Washer?
- J
  julialopezAug 19, 2025
  If your Videocon Washer's spinning basket does not stop, the brake shoe might be worn off or broken, requiring replacement. Alternatively, the brake arm may not be moving, necessitating replacement of the brake frame. Another potential cause is a broken or insufficiently elastic brake spring, which should also be replaced.
R
Ronald MillerAug 25, 2025
Why is my Videocon SPRING-WM VSP70LPW-SFK Washer making excessive noise during agitation?
- T
  Tiffany PerryAug 26, 2025
  If your Videocon Washer is making excessive noise during agitation, check for coins or buttons trapped between the pulsator and tub and remove them. If the bearing case is defective, replace it. Also, inspect the pulley or transformer fixing and adjust the pulley or replace it if defective.