Rev AA i
Compliance Information
For Customers in the European Union
This equipment displays the CE mark to indicate conformance to the
following legislation:
For Customers in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide responsible protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
BS EN55022:2006 + A1:2007 Class A Emissions Standard for industrial environments
BS EN61000-6-4 2007 Generic Emissions Standard for Heavy Industrial
Environments
BS EN61000-3-2 2006 Harmonic Current Fluctuations
BS EN61000-3-3 2008 Voltage Fluctuation and Flicker
BS EN61000-6-2 2005 Immunity Characteristics for Industrial Environ-
ments
Following the provisions of EU EMC Directive 2004/108/EC
EC Low Voltage Directive 2006/95/EEC
Essential health and safety requirements relating to electrical equipment designed for use within
certain voltage limits.
IEC 60950-1:2001
Safety requirements for information technology equipment including electrical business equipment.
EN 60529:1992
Degrees of protection provided by enclosures (IP code).
To Next Page
Loading...