Videx 2 Wire ESVK/6388 Series - Memory Board

66550033-EN - V6.1 - 15/08/20
- 26 -
ESVK/6388 Series “2 wire Bus” videokit
ESVK/6388 Series - Installation handbook
SLAVE MODE  SW2.4
This set up concerns the answering mode of the video monitor when there is more than one unit (max 4) in the same
apartment. OFF (default) = during a call, only the video monitor with extension 1 (master) will show the video. ON = the
video monitor will be switched on independently of the extension address: in this case the video monitor must be sup-
plied locally using a power supply Art.2321 or Art.AMR-12, see notes on 12M and VA on “Connection Terminals Signals”
table (the local power supply is required for each black & white slave videophone or starting from the third slave videophone when
they are all colour videophones).
If you set for one slave videophone, you must set ON the same switch also for the relevant master videophone.
ON
1 2 3 4
SW2.4
CONNECTION TERMINALS SIGNALS
BUS1 Bus input
BUS2 Bus input
GND Ground
12M
+12Vdc power supply input (Art.323/12 or Art.AMR2-
12) for version with Memory Board option or auxiliary
power supply input (to be used when two or more slave
monitors are ringing together with the switch 4 of SW2
is set to ON)
GND Ground
VA
+30Vdc power supply input (Art. 2321) to be used
when two or more slave monitors are ringing togeth-
er with the switch 4 of SW2 set to ON
C
Dry contact. Internally linked to NO
when the
button is pressed.
Max 35Vdc,
50mA
NO
Dry contact. Internally linked to C
when the
button is pressed.
DOL Auxiliary LED power supply input (ground)
+DOL Auxiliary LED power supply input (+12Vdc)
GND A
Ground output for use in combination with AL & LB
active low inputs
LB Local bell input (active low)
AL Alarm input (not implemented yet)
TECHNICAL SPECIFICATION
Housing/Mounting: 6300 Series Videophones
surface mount
Push buttons: Yes, 4
Programming: Yes, carried out by the buttons and
the dip-switches located on the rear
of the videophone
Controls: Call tone volume, picture hue,
brightness and contrast
Power Supply: Supplied by the BUS line
Power consumption: Stand-by: 0.2mA
Operating: 115mA
Working Temperature: -10 +50 °C
MEMORY BOARD
This device is also available in the version with memory board (Art.6388/VM).
If you have that version, please refer to the “6200, 6300, 6400 and 6700 Series Memory Board” user manual (in
English and Italian) for installation and use.
The manual is available for download: click/tap or scan the QR code.
Art.6388 3.5" colour display videophone